LoRa32 compatible with Arduino development board SX1262 ESP32-S3 OLED WIFI Meshtatic 433-510mhz/868MHZ-915MHZ

Note: You can choose to have a casing or not

• •  

     

    Description

    WIFI Kit series is the new development of the cost-effective networking program,the main chip using Lexin ESP32,Tensilica LX6 dual-core processor,clocked at 240MHz,computing power up to 600DMIPS,chip built-in 520 KB SRAM,802.11 b / g / N HT40 Wi-Fi transceiver,baseband,protocol stack and LWIP,integrated dual-mode Bluetooth (traditional Bluetooth and BLE low power Bluetooth).

     

    This product is based on the WIFI Kit 32 added SX1278 chip,that is,LoRa remote modem,433MHz frequency,about -148dBm high sensitivity,+20 dBm power output,high reliability,transmission distance (measured open area communication distance 2.6Km).

     

    Onboard 32MByte Flash,Wi-Fi antenna,0.96-inch blue OLED display,lithium battery charging circuit and interface,CP2102 USB to serial chip,the perfect support development environment,can be very simple and fast for program verification and product development.

     

    Operating voltage: 3.3V to 7V

    Operating temperature range: -40 ° C to + 90 ° C

    Supports Sniffer,Station,softAP and Wi-Fi Direct modes

    Data rate: 150 Mbps @ 11n HT40,72 Mbps @ 11n HT20,54 Mbps @ 11g,11 Mbps @ 11b

    Transmit power: 19.5 dBm @ 11b,16.5 dBm @ 11g,15.5 dBm @ 11n

    Receiver sensitivity up to - 98 dBm

    UDP continues to throughput by 135 Mbps

    Onboard WIFI function

     

    LoRa send and receive test

     

     

     

    Perfect support development environment,Win 7 above operating system without manual installation of the driver,you can brush NodeMCU firmware,a lot of technical information and routines,please submit the order to the customer service request.

  • CFsunbird

Package Included:

1 x   WIFI LoRa 32 board ( soldered pins+pin stickers) + Antenna