LAUNCHXL-F28379D Development Board，LaunchPad evaluation board kit for C2000 Delfino MCU

Hardware features

• USB connected isolated XDS100v2 JTAG debug probe for real-time debug and flash programming

• 4x 20-pin headers/connectors

• Programmable buttons and LEDs

• Hardware files can be found by downloading C2000Ware inside this folder: boards\LaunchPads\LAUNCHXL_F28379D

• TMS320F28379D: 200 MHz dual C28xCPUs and dual CLAs, 1 MB Flash, 16-bit or 12-bit ADCs, comparators, 12-bit DACs, delta-sigma sinc filters, HRPWMs, eCAPs, eQEPs, CANs and more

• C2000 Delfino™ MCU position manager-ready TMS320F28379D MCU capable of interfacing to absolute encoders as well as resolvers and SINCOS transducers

• Supports two BoosterPack™ Plug-in Modules

• Two encoder interface connectors

• Isolated CAN transceiver connector

Software features

• Free download of Code Composer Studio™ IDE

• Free download of C2000Ware for device drivers and example projects

  • DesignDRIVE platform support

  • powerSUITE software support

• MathWorks Embedded target support

• solidThinking Embed support

Recommended BoosterPacks

• BOOSTXL-DRV8301

• BOOSTXL-DRV8305EVM

• BOOSTXL-BUCKCONV

• BOOSTXL-3PHGANINV

• TI BoosterPack Checker for an interactive list of compatible BoosterPacks

Get started

• For DesignDRIVE
  • controlSUITE
    • BOOSTXL-DRV8305EVM or BOOSTXL-3PHGANINV

      • Follow the documentation at: C:\ti\controlSUITE\libs\app_libs\motor_control\libs\FCL_SFRA\v01_00_00_00\Examples\FCL_SFRA_379DXL_v1\~Docs

    • BOOSTXL-POSMGR

      • Follow the documentation at: C:\ti\controlSUITE\development_kits\BOOSTXL_POSMGR

• For general device evaluation

  • Install Code Composer Studio IDE and C2000Ware

  • Connect the LaunchPad using the included mini-USB cable to a computer

  • Open a serial terminal program of your choice (Putty, HyperTerm, etc.) and configure it to access the LaunchPad virtual COM port with 115200 Baud, 8-bit data, No parity, and single stop Bit. The COM port number can be found by opening your computer’s Device Manager

  • When connected to your computer, the LaunchPad will power up and flash the red and blue LEDs for approximately 3 seconds. After the LEDs complete flashing, the LaunchPad will enter an ADC sample mode

  • The terminal will display the latest ADC sample reading based on ADCIN14 (Pin 23 of the BoosterPack header) at a one second interval

    • If the sample is below mid-scale (1.5V/2048) the blue LED (D10) will light

    • If the sample is above mid-scale the red LED (D9) will light

  • Build and load other examples in C2000Ware

  • View and run the 1-day On-Line Workshop

  • View and run the Multi-day On-Line Workshop

  • Ask questions on the TI C2000 e2e forum