STC-1000 Temperature Controller Thermostat Thermoregulator Incubator Relay Brewing Incubator Heater Cooler 12V 24V 220V

STC-1000 Temperature Controller Thermostat Thermoregulator Incubator Relay Brewing Incubator Heater Cooler 12V 24V 220V

Switch the modes between cool and heat;Control temperature

setting the temperature setting value and the difference value;

Temperature calibration; Refrigerating control output delay protection; Alarm when temperature exceeds, temperature limit or when sensor error.

Specification:

Front panel size:75(L)×34.5(W)(mm)

Mounting size:71(L)×29(W)(mm)

Product size:75(L)×34.5(W)×85(D)(mm)

Sensor length:1m(include the probe)

Feature:

• Temperature measuring range:-50℃~99℃

• Resolution:0.1℃

• Accuracy:± 0.1℃(-50℃~70℃)

• sensor error delay:1 minute

• Power supply:220VAC±10%,50/60Hz

• Power consumption:<3W

• Sensor:NTC sensor(1PC)

• Relay contact capacity:Cool(10A/250VAC);Heat(10A/250VAC)

• Ambient temperature:O℃~60℃

• Storage temperature:-30℃-75℃

• Relative humidity:20~85%(No condensate)

Key operation instruction:

• The way to check parameter:

Under normal working status,press and release ""key once

instantly,it displays temperature setting value;press and

release ""key once instantly,it displays the difference value.It

back to display the normal temperature display status in 2s.

• The way to set parameter:

Under controler normal working status,press "" key for 3s or more

to enter parameter modifying mode,and the “Set”

indicator light on,sereen displays the first menu code F1.Press

"”key to avoid the interference,the sensor down-lead and

power wire should be kept a distance or "" key to page up and page

down menu item to find accordingly code,press"”key to display

the parameter set value of the current menu.Press and hold ""key

Press "" key or "" key again to adjust up and down the parameter

setting value of the current menu item.

Press and hold both ""key and ""key or “"

key simultaneously to choose and adjust the parameter value of

current menu value promptly.After finishing the setting

press and release the"" key instantly to save the parameter modified

value and return to display the normal temperature

value.If no key operation vwithin 30 seconds,system won't save modified

parameter,screen back to display normal temperature.

Screen display“Er"if error appears during parameter saving and

Back to nomal working status in 3 seconds.

• Restore system data:

When electrified,system will check itself,screen will display "Er" if error exist,please press any key at this time,and it restore default value and enter in to normal working mode.It is advised

reset the parameter value under this condition.